KATALOOGITOOTED

Prindi

 

  • LCD ostsilloskoop ( konstruktor )

    Tootekood:

    WSEDU08

    Kirjeldus:
    Build your own oscilloscope and learn how to visualize signals. See the signals you learn about in real life! Despite the low cost, this oscilloscope has a lot of features found only on expensive units like signal markers, frequency, dB, true RMS readouts,... A powerful auto-setup function will get you going in a snap! [i]Note:[/i] This scope cannot be used to perform measurements on voltages higher than 30Vpp.
    Specifications:
    1. high contrast LCD: 64 x 128 pixels with white LED backlight
    2. maximum sample rate: 1MS/s for repetitive signals, 100kS/s in real time
    3. input amplifier bandwidth: 200kHz (-3 dB)
    4. measurements can be performed up to: 100kHz
    5. input impedance: 100kohm // 20pF
    6. maximum input voltage: 30Vpeak (AC + DC)
    7. input coupling: DC and AC
    8. AD resolution: 8 bits
    9. run modes: run, single
    10. trigger level adjustable: in 16 steps
    11. timebase range: in 15 steps, 10µs/division to 500ms/division
    12. input sensitivity range: in 6 steps, 100mV/division to 5V/division
    13. test output: 1.95kHz / 3.3Vpp
    14. full auto set up for: Volt/div and time/div (or manual)
    15. sensitivity down to 10mV
    16. readouts: DC, AC+DC, true RMS, dBm, Vpp, min. & max.
    17. time and voltage markers readout
    18. frequency readout (through markers)
    19. battery operated: 4 x AAA batteries (max. 100mA)
    20. power save mode
    21. dimensions: 80 x 115 x 40 mm / 3.14 x 4.52 x 1.57"
    22. weight: 190g (6.70 oz) with batteries
      manual: WSEDU08.pdf
    Dokumendid:
    Tellimisel

    Hind km-ga:

    65.23 €